Loewe Reference lD 55 User Manual page 26

Reference ID 40-55
User guide
Initial installation
Setting options for the satellite system
(max. 4 satellites on DiSEqC multiswitch):
DiSEqC
multiple
Settings DiSEqC multiple switch
switch
With the refresh rate you determine how often a DiSEqC command is output. This is only
necessary in a cascaded system. Your system provider will bei able to tell you more about
this.
Repeat rate
Control voltage 13 / 18V
22kHz signal
Toneburst
Back with
Select and adapt settings for the DiSEqC
multiswitch.
OK Adopt settings.
Repeat rate The refresh rate determines how often a DiSEqC
command is output. A refresh is only necessary with
cascaded systems.
Control The control voltage controls the switching of the
voltage polarisation level (horizontal/vertical) in non-DiSEqC
capable components (e.g., control of single LNBs via
DiSEqC multiswitch).
22kHz signal The 22 kHz signal controls the switching between
high and low band in the Band setting. The Position
setting controls the selection of the satellites in non-
DiSEqC capable components.
Toneburst The Toneburst controls the selection of the satellites
in non-DiSEqC but Toneburst capable components
with the Position and Option settings.
Proceed to next step.
Satellite
selection
Select satellites
Please select satellite 1 to satellite 4.
Note: The newly selected parameter must be confirmed with the
Satellit 1 Satellit 2
none
Optus D1160°E
Türksat 42°E
Hellas Sat2 39°E
Eutelsat 36A 36°E
Eutelsat 28A 28,5°E
ASTRA2 28,2°E
Back with
Mark Satellite 1 ... Satellite 4,
Select satellite.
OK Adopt settings.
Proceed to next step.
26
none 1 2
off on
Band Position off
off Position Option
Proceed with
button.
OK
Satellit 3 Satellit 4
ASTRA3 23,5°E Thor/Intelsat10-02 0,8
ASTRA1 19,2°E Eutelsat 5 West A 5°W
Eutelsat 16A 16°E Nilesat 7°W
Eutelsat 7 West A 7,2°W
Hot Bird 13°E
Eurobird 9A 9°E Eutelsat 8 West A 8°W
Eurobird 7A 7°E Eutelsat 12 West A 12,5°W
ASTRA4A 4,8°E Telestart12 12,5°W
Proceed with
LNC
. .
LNB frequencies
frequencies
Please select the LNB frequencies for both High and Low Bands.
Note: The newly selected parameter in each case must be confirmed with the
ASTRA1 19,2°E low band
ASTRA1 19,2°E high band
Hot Bird 13°E low band
Hot Bird 13°E high band
Eutelsat W2 16°E low band
Eutelsat W2 16°E high band
Türksat 42°E low band
Türksat 42°E high band
Back with
Set LNB frequencies.
Normally, you do not need to change the values.
OK Adopt settings.
Proceed to next step.
Proceed with Setting options for DVB-S reception
(continued).
button.
OK
9750 MHz 10000 MHz 10200 MHz 10600 MHz
10600 MHz 10750 MHz 11000 MHz 11250 MHz
9750 MHz 10000 MHz 10200 MHz 10600 MHz
10600 MHz 10750 MHz 11000 MHz 11250 MHz
9750 MHz 10000 MHz 10200 MHz 10600 MHz
10600 MHz 10750 MHz 11000 MHz 11250 MHz
9750 MHz 10000 MHz 10200 MHz 10600 MHz
10600 MHz 10750 MHz 11000 MHz 11250 MHz
Proceed with