Care, Cleaning & Storage - Breville the Smart Air LAP168 Instruction Book

Care, Cleaning
& Storage
The air purifier and filter should be cleaned at
least once every month. Ensure the air purifier
is switched off and disconnected from the
power outlet before cleaning or storing.
• Use a clean, dry cloth to clean all external
surfaces of the air purifier.
NOTE
More frequent cleaning may be required
depending on environmental conditions.
BREVILLE RECOMMENDS
• Always ensure the air purifier is turned
off, switched off at the power outlet and
unplugged before performing any cleaning
or filter replacement.
8
DO NOT stick any foreign objects or your
fingers inside the air inlet/outlet of this unit.
8
DO NOT use gasoline, benzine, thinner,
harsh cleaners, etc. on and/or in the unit
while cleaning as they will damage the unit.
8
NEVER use alcohol or other solvents
on this unit.
FILTER CLEANING AND REPLACING
WARNING
The filter is not washable. Do not immerse any
part of the air purifier in water as it will cause
damage.
• The Pre-filter should be cleaned at least once
every month using a vacuum cleaner. Gently
vacuum using a hand-tool attachment such
as a brush or upholstery tool. Clean more
often if required.
• Do not use any solutions, hard bristle
brushes or sharp objects to clean as this
can cause damage.
• Replace the filter as indicated using the
instructions following.
14
REPLACING THE FILTER
Your Smart Air Viral Protect Night Glow
TM
Purifier filter should be replaced in the time
frames indicated below.
• The filter life is approximately 12 months
based on daily operation of 12 hours per day
or 4320hrs in total*.
• Recommended replacement every 6 to
12 months, or 4320 hours, depending on
severity of symptoms/sensitivity levels,
frequency of use and air quality. More
frequent replacements will provide optimal
benefits.
• The filter life may vary to this timing,
depending on environmental conditions.
• Remove all packaging from the replacement
filter and place the filter into the unit as
described below.
1. Carefully turn your air purifier upside down
and turn the base anti-clockwise to remove
the base from the unit.
2. Remove the used filter, being careful that
any residue or debris that may fall from the
filter will not cause damage.
3. Insert the replacement filter into the unit,
ensuring that it is correctly fitted and
centred.
4. Replace the base and turn clockwise to
secure.
5. Return the air purifier to an
upright position.
6. Turn on the air purifier then press and
hold the POWER button for 5 seconds
to reset the Filter Reset light.
NOTE
There is no top or bottom on the filter. The
filter can be placed into the unit either way.
NOTE
If the filter is not in place or not fitted correctly,
the air purifier will not operate.