Table of Contents
Advertisement
Preparation for CGI
commands
This document provides information on how to
make settings via the network using the CGI
commands supported by this device.
To use the CGI command function of this unit,
some pre-configurations are required. These
pre-configurations are described below.
Network Function Usage Setting
To use the CGI commands of this unit, it is
necessary to make the network function usage
setting to be enabled in advance so that
communication via the network is possible.
Connect the HDMI OUT terminal of the camera to
the video monitor, or connect the VIDEO OUT
terminal of the camera to the PC. Operate the
infrared remote to display the SYSTEM menu.
Change the NETWORK setting to ON. Turn off the
power of the camera once, then turn it on again
to start the camera.
IP Address Settings by RM-IP
Setup Tool
To enable the device to communicate with the
camera appropriately, IP address settings is
required. Set IP address based on your network
environment using RM-IP Setup Tool. This is in
order to set IP address. For details, refer to "RM-
IP Setup Tool Guide."
Notes
• IP address is set to 192.168.0.100 as default.
• After setting the network setting to ON, or after
about 20 minutes have passed since the power
was turned on with the network function usage
setting enabled, the setting cannot be
changed automatically from the RM-IP Setup
Tool.
Changing Initial Password
After the process described above is performed,
you can HTTP access to the cameras. Access to
the cameras using Web browser. To access,
enter the IP address of the cameras to the
address bar in the Web browser, then press
Enter.
You will be required to enter username and
password, then enter Admin's username and
password. Admin's username and password of
default are below:
Admin username: admin
Password: Admin_1234
At the initial access (with default admin
password not changed), you need to change the
admin password. Set the admin password on
user setting window displayed. To change the
password, you need to enter the default
password in Current password field.
When you press "OK," the user setting will be
changed. Once the setting is changed, you will
be requested to enter admin username and
password again. Enter the admin username and
password you changed in the previous step.
About Authentication
This device supports HTTP/RTSP Digest
authentication defined by IETF RFC 2617.
To use CGI commands on this unit,
authentication at the necessary level is required.
When you build software to achieve CGI
command communication with the camera,
build HTTP header to authenticate appropriately
for HTTP 401 Unauthorized response as the
response of command request.
Note
If authentication errors are repeated from the
same computer, the subsequent request may be
regarded as Brute-force attack. Build the
software to add credential information with
appropriate user/password in case of HTTP 401
response reception.
43
Advertisement
Table of Contents
