Dell Networking S3100 Series Getting Started Manual page 15

Figure 8. Installing a Fan Tray
Installing a Plug-In Module (Optional)
The S3100 series switches support optional small form-factor pluggable plus
(SFP+) or 10GBase-T modules.
When hot swapping optional modules, the following module behaviors
should be noted:
• The configuration of the port is retained when an existing module is
replaced with one that is the same.
• Replacement of an optional module with one that is different results in the
new module being moved into an error state.
• Modify the configuration of the optional module interfaces only when the
module is installed.
CAUTION: Do not insert the replacement module immediately after
removing the original module. When removing the optional module,
the syslogs must first be removed prior to installing the replacement
module.
After a module is recognized, its configuration is stored locally on the switch
as the switch default. Users can modify the configuration of these interfaces
only if the optional module is present. The module configuration appears in
the running configuration for informational purposes. For more information,
see the Dell Configuration Guide for the S3100 Series.
Installation
15