Solid-State Drive (For 2-In-1 Computers); Removing The M.2 2230 Solid-State Drive (For Computers Shipped With A Thermal Plate) - Dell P135G Service Manual

Next steps
1. Install the base cover.
2. Follow the procedure in
3. Verify if the storage device is installed correctly:
a. Turn on or restart your system.
b. Press F2 when the Dell logo is displayed on the screen to enter the system setup (BIOS) program.
NOTE: A list of storage devices are displayed under the System Information in the General group.
c. If you have replaced the primary storage device that had the operating system installed, search in the Knowledge Base
Resource at www.dell.com/support.
M.2 solid-state drive (for 2-in-1 computers)
Removing the M.2 2230 solid-state drive (for computers shipped
with a thermal plate)
Prerequisites
1. Follow the procedure in
2. Remove the base cover.
About this task
NOTE: This procedure applies only to computers shipped with a M.2 2230 solid-state drive installed.
NOTE: The M.2 card that is installed on your computer depends on the configuration ordered. Supported card
configurations on the M.2 card slot are:
● M.2 2230 solid-state drive
● M.2 2280 solid-state drive
The following images indicate the location of the M.2 2230 solid-state drive and provide a visual representation of the removal
procedure.
26 Removing and installing components
After working inside your
Before working inside your
computer.
computer.