Greasing The Bearings; Check Engine Oil Level - Toro Z255 Operator's Manual

Greasing the Bearings

Make sure cutting unit spindles are full of grease
before engine is first started.
Grease with No. 2 general purpose lithium base or
molybdenum base grease.
1. Grease the fittings on the three spindle bearings.
Grease until it comes out lower seals (Fig. 9).
Figure 9
1. Spindles

Check Engine Oil Level

Before you start the engine and use the machine,
check the oil level in the engine crankcase; refer to
Checking Oil Level, page 41.
1
m–3890
Assembly
23