Product Feature Identification; Safety Notices - Tannoy CVS Series Quick Start Manual

Hide thumbs Also See for CVS Series:

Quick start manual (36 pages)

Quick start manual (13 pages)

Quick start manual (13 pages)

Table Of Contents

Table of Contents

Available languages

CVS (EN 54) Series

1. Introduction

Thank you for purchasing this Tannoy Ceiling loudspeaker. This product range is suited for high-level music and speech reinforcement applications requiring

exceptional sonic quality with uncompromised reliability.

2. Unpacking

Every Tannoy product and accessory is carefully inspected before packing. After unpacking, please inspect your product to make sure no damage has occurred in

transit. In the unlikely event of any damage, would you please notify your dealer immediately and retain your shipping carton, as your dealer may ask you to return the

faulty unit to them for inspection.

Each CVS (EN54) loudspeaker is packed in pairs and provided with the following accessories as standard; C-Ring, tile-bridge kit, cut-out template, and paint mask.

A plaster (mud) ring is also available as an optional extra.

3. Safety Notices

Some regional construction codes require the use of a secondary method of securing loudspeakers in ceiling to provide security of a backup support. A secondary

support line should be attached from the safety loop on the rear of the product to a source point on the ceiling. Please consult the relevant construction codes in

your region.

When using a power driver to install the product it is essential to use the correct torque level settings to avoid over tightening and damage to the ceiling material

or clamps.

Recommended torque setting: 1.5 Nm.

Tannoy will not be held responsible for any damages caused by the improper installation of these loudspeakers.

SAFETY NOTE:

In order to comply with the relevant fire safety regulations (ie. BS 5839: 1998), it is required that in the event of fire, that failure of the circuit to which the loudspeaker is connected does not occur before evacuation of the building is complete. Suitable measures include:

- a) use of terminal blocks (for connection to primary) with a melting point of not less than 650°C, for example constructed from ceramic materials; b) use of terminal blocks of a lower melting point but protected with thermal insulation; c) use of terminal blocks such that,

on melting, an open-circuit or a short-circuit does not occur.