Honda CRF50F Owner's Manual page 88

37GJGA00.book 78 ページ ２０２１年３月５日 金曜日 午後２時５０分
Installation:
1. Reverse the removal procedure. Make
sure that the lug (1) on the swingarm is
located in the slot (2) in the brake panel.
Tighten the rear axle nut to:
46 N·m (4.8 kgf·m, 35 lbf·ft)
2. Adjust the drive chain (pages 71 – 72).
3. Adjust the brake (page 23).
4. Apply the brake several times and check
for free wheel rotation after the brake
pedal is released.
If a torque wrench is not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
78
(2)
(1) Lug (2) Slot
(1)