4
|
Operation
4.6.3 Reading out information
4.6.4 Configuring date, time, units of measurement, contrast and backlight
User reference guide
38
You do NOT have to change your schedule or holiday configuration.
To read out information
Prerequisite: You switched the permission level to Advanced end user.
1 Go to [6]:
> Information.
Possible read-out information
In menu...
[6.1] Sensor information
[6.2] Energy metering
[6.3] Error handling
[6.4] User permission level
[6.5] Actuators
[6.6] Operation modes
[6.7] Running hours
[6.8] Version
To configure time and date
Prerequisite: You switched the permission level to Advanced end user.
1 Go to [1]:
> Set time/date.
INFORMATION
Switch to Adv. end user to change daylight saving time and 12/24h notation.
To configure units of measurement
Prerequisite: You switched the permission level to Advanced end user.
1 Go to [7.6]:
> User settings > Unit of measurement.
Possible units of measurement settings
Setting
Decimal point
Temperature
You can read out...
Room, tank or DHW, outside, and
leaving water temperature. (If
applicable)
Produced energy, consumed electricity,
and consumed gas.
Error history and contact/helpdesk
number.
Current user permission level.
Status/mode of each actuator.
Example: Domestic hot water pump
ON/OFF.
Current operation mode. Example:
Defrost/oil return mode.
Running hours of the system.
Version information about the system.
Possible units of measurement
▪
Dot
▪
Comma
▪
°C
▪
°F
EHFZ03S18DJ3V
Daikin Altherma 3 R F
4P596825-1A – 2021.10