Table of Contents
Advertisement
How to Install the Unit
1
Measure the space for installation to assure a
good fit. The air conditioner must be installed
firmly into place to prevent vibration and noise.
2
Avoid exposure to direct sunlight.
3
Remove all obstacles from the rear of the
unit. There must be at least 50 cm (20 in.)
of cleared space around the rear of the unit.
Obstacles restricting the airflow may reduce
the cooling efficiency of the unit.
4
The unit should be installed with a slight tilt
towards the outside to allow condensed water
to drain. (About 10~15 mm or 1/4 bubble with
Level)
Foam
Cooled air
CAUTION
• The external grille must be exposed outside for
air discharge.
Preparation of the Cabinet
1
Remove 4 screws which fasten the cabinet at
both sides and at the back. (Keep the screws
for later use.)
Shipping
Shipping
Screws
Screws
10
Fence
Awning
Heat
radiation
10~15 mm
Over 50 cm
1/4 Bubble
Level
2
Slide the unit from the cabinet by gripping the
base pan handle and pulling forward while
bracing the cabinet.
CAUTION
• The unit is heavy. To prevent injury, use proper
lifting techniques when pulling unit forward
from cabinet. Obtain assistance from another
person if possible.
Drainage (Optional)
The base-pan may overflow due to high humidity.
To drain the excess water, remove the drain cap
from the base pan of the unit and secure the Drain
Pan.
1
Remove the rubber cap from the hole under
the base-pan.
2
Install the drain pan over the corner of the
cabinet with 2-4 screws.
3
Connect the drain hose to the outlet located
on the bottom of the drain pan. (You can
purchase the drain hose or tubing locally to
satisfy your particular needs. Drain hose is not
supplied.)
Cabinet
Cabinet
Drain Hose
Drain Hose
EN
Drain Pan
Drain Pan
Screw
Screw
Advertisement
Table of Contents
