Hunter 44378 Owner's Manual page 34

5. SPAN 1: The next menu option is to set your thermostats primary span. Use the
or buttons to adjust between 1, 2, or, 3 degrees. Press
"Updated" and return to menu options or press
The span setting regulates when and how long your system will run. The span has
been set at the factory to 1 which will allow the system to turn on 1
above or below the set temperature and run for 1
set temperature.
Example: If your thermostat is set to turn on at 72
of 2, your thermostat will activate your furnace at 71
73 . For cooling at 72
O
and shut down at 71
running time while 3 will lengthen it.
6. SPAN 2: Unless you have a multi-stage conventional or heat pump system, there
is no need to change the second or third stage span. If you do, use the
buttons to adjust between 1, 2, or, 3 degrees. Press
changed or if you need to make no changes. Second stage span acts the same as
your primary, but it determines when and how long your second stage heat runs.
7. TEMP F/C: The thermostat can change your temperature reading between
Fahrenheit and Celcius. Use the
(F) and Celsius (C) Press
options or press
34
Menu Options
with a span of 2, your air conditioner will activate at 73
O
. This setting can be changed to 1, 2, or 3. 1 will shorten your
O
, the screen will flash "Updated" and return to menu
Next
to return to the home screen.
Done/
Home
44126-01 • 07/30/2012
to return to the home screen.
Done/
Home
F (.05
O
in heat mode, with a span setting
O
and shut it down when it reaches
O
or buttons to switch between Fahrenheit
, the screen will flash
Next
F (.05
O
C) above or below the
O
once this has been
Done/
Home
C)
O
O
or