Chapter 5
Certification
Section 5.1.5
FCC
This device has been tested and found to comply with the limits for a Class A digital device, pursuant to Part
15 Subpart B of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment.
This device generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case users will be required to
correct the interference at their own expense.
IMPORTANT!
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate this device.
Section 5.1.6
Other Approvals
This device meets the requirements of the following additional standards:
• IEEE 1613
IEEE Standard Environmental and Testing Requirements for Communications Networking Devices in Electric
Power Substations
• IEC 61850-3
General Requirements
• IEC 870-2-2
Telecontrol Equipment and Systems – Part 2: Operating Conditions – Section 2: Environmental Conditions
(Climatic, Mechanical and Other Non-Electrical Influences)
• MIL-STD-810F
Department of Defense Test Method Standard for Environmental Engineering Considerations and Laboratory
Tests – Method 509.4 (Salt Fog)
Section 5.2
EMC and Environmental Type Tests
The RUGGEDCOM WIN7035 has passed the following Electromagnetic Compatibility (EMC) and environmental
tests.
EMC Type Test for IEC 61850-3
Standard
Climatic Environmental Conditions
IEC 60068-2-1
IEC 60068-2-2
36
Method
IEC 61850-3 (5.2)
Low Temperature (Operational)
IEC 61850-3 (5.2)
High Temperature (Operational)
Description
RUGGEDCOM WIN7035
Installation Guide
Test Levels
-40 °C (-40 °F), 16 Hour Dwell
-65 °C (-149 °F), 16 Hour Dwell
FCC