Component Connections (For Dvd) - Samsung DVD-CM250 Instruction Manual

DVD
DVD Only
COMPONENT VIDEO OUT
GB
S-VIDEO OUT
To Component
Input on Your TV
Press "OK" to confirm
Prorgessive scan mode.
Otherwise press "RETURN".
Please set your TV to component
input. If your TV doesn't have
Progressive scan mode, there will
be no signal on the screen.
50

Component Connections (for DVD)

Component video output is available only for DVD playback. RF
and Line input are available for Tuner and VCR playback.
SPEAKERS
FRONT R FRONT L WOOFER
If your TV set supports Progressive Scan, it can transmit Pr, Pb, and
1
Y signals separately, so you can enjoy sharp and clear picture.
SURROUND R SURROUND L CENTER
What is Progressive Scan?
It is a set of jacks that can provide sharp and clear picture
quality by using twice the number of fields of lines than
component output.
1
Connect the component output of the DVD player to your TV set.
Use the component cable to connect the component output on the
back panel of the DVD-VCR to the component input of your TV.
If you mix up the connections when connecting the component cable,
the picture will appear reddish or bluish.
2
Set your TV to COMPONENT.
Select component input as your TV's AV input. At this point, even
if the picture appears reddish, it is normal.
3
Press the P.SCAN button on the front panel.
If the P.SCAN button on the front panel of the DVD-VCR is
pressed, a Green LED will light up and the following message will
be displayed:
To activate Progressive Scan, press OK.
The following message will be displayed and then the picture will
be played in Progressive Scan mode.
4
To deactivate Progressive Scan, press the P.SCAN button again.
If the P.SCAN button on the front panel of the DVD-VCR is
pressed again, a Green LED will light up and Progressive Scan
mode will be canceled. Select another mode as your TV's AV input
to view another output of the DVD-VCR.
This is available only for a TV set that supports Progressive Scan.
• While Progressive Scan is active, video, S-video, and SCART
output are not available.
• To activate Progressive Scan, the DVD-VCR must be in Stop
mode.
You can listen to audio sound through AUX audio output or 5.1CH
speakers while watching Component or S-Video output.