Samsung DVD-CM250 Instruction Manual page 67

About Speaker Setup
To Set the Speaker Balance
1
Press the SPEAKER button.
Each time you press the button, the selection will change as
follows: FL C FR
2
Press AMP VOL + and AMP VOL - buttons to adjust the speaker
volume.
The volume can be adjusted to a level between –10 and +10.
To Test the Speakers
1
In Stop mode, press the TEST button.
The test tone will be output to the speakers in the following
order: FL (Front Speaker/L)
Speaker/R) SR (Surround Speaker/R)
Speaker/L) SU (Subwoofer).
A hissing sound from a speaker indicates that the speaker is
installed correctly.
2
To end the speaker test, press the TEST button again.
• While the test tone is being produced, you can use the VOL
buttons to set the speaker balance for the selected channel.
• While the subwoofer is being tested, a low bass sound of
100Hz or 125Hz will be heard.
To Set the Bass/Treble
1
Press the BASS or TREBLE button.
Each time you press the BASS or TREBLE button, the
corresponding setting will turn on or off.
2
Use AMP VOL + and AMP VOL - buttons to adjust the bass or
treble of the speakers.
The bass or treble can be adjusted to a level between –10 and
+10.
SR SL SU VOL.
C (Center Speaker)
SL (Surround
1
FR (Front 1,2
FL
FRONT SPEAKER
LEFT
SL
SURROUND SPEAKER
LEFT
2
2
C FR
CENTER SPEAKER FRONT SPEAKER
RIGHT
SUB
WOOFER
SUB WOOFER
SPEAKER
SR
SURROUND SPEAKER
RIGHT
1
1
2
2
67
GB