Drain Water; Drainage Method - Sharp UL-C10EA-W User Manual

10
Install Power Cord Hooks
Assemble the power cord hooks at the back of the unit with screws (the
direction of power cord hooks is as shown in following figure).
Wind the power cord around the power cord hooks.

Drain Water

• To reach the maximum performance, it is not recommended to drain
water, during Cooling mode.
• It is recommended to use the middle drainage port to drain water,
during Dry mode.
• It is recommended to use the middle drainage port to drain water,
during Heating mode.
• To drain water from the bottom drainage port when th edisplay shows
H8.

Drainage method

1 Drain water from the bottom drainage port.
• Turn off the unit and pull out the plug from the socket.
• Place a water container under the bottom drainage port, or move the
machine to a place where it can drain.
• Remove the rubber plug of the bottom drainage port to drain water.
• After draining, insert the rubber plug.
• Press ON/OFF button to restart.
2 Drain water from the middle drainage port.
NOTE
ū Water can be automatically emptied into a floor drain by attaching
13 mm inner diameter hose (not included).
1. Remove the continuous drain cap by turning it counter clockwise then
remove the rubber stopper from the spout.
2. Screw the drain connector to (included in the package) the spout by
turning clockwise.
3. Insert a 13 mm inner diameter hose (not included) onto drain
connector.
ATTENTION:
ū When using continuous drainage option from the middle hole, place
the unit on a level surface and make sure drainage hose is clear of any
obstructions and is directed downward. Placing the unit on an uneven
surface or improper hose installation may result in water filling up the
chassis and causing the unit to shut off. Empty water in the chassis if
shut off occurs, then check the unit location and hose for proper setup.
Installing Heat Discharge Pipe
Install heat discharge pipe
1. Rotate joint A and Rear clip clockwise into the two ends of heat
discharge pipe.
joint A
heat discharge pipe
2. Insert joint A of heat discharge pipe into the groove until you hear a
clicking sound.
clockwise
rear clip