Table of Contents
Advertisement
Fig. 9-7
Fig. 9-8
Fig. 9-9
Fig. 9-10
Check the appliance is electrically safe when you have finished.
Locating
peg
Rubber grommet
INSTALLATION
Fitting the Handles
The handles for the grill door and tall oven will require fitting
as follows:
Open the door. To keep the door open, either place a suitable
weight on it (grill door only) or have someone hold it.
Fit the handle threaded bolts through the front of the door
(Fig. 9-7). With the handle in place, fit the nut locating pegs
into the handle threaded bolts (Fig. 9-8).
Slide the retaining nuts over the pegs (Fig. 9-9) and, using
the spanner supplied, secure in place.
Remove the locating pegs and refit the grommets.
Repeat for the other door.
Carefully fit the rubber grommets supplied (Fig. 9-10).
Levelling
You are recommended to use a spirit level on a shelf in one of
the ovens to check for level.
Place the cooker in its intended position, taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level the
cooker.
To adjust the height of the rear of the cooker use a 13 mm
spanner or socket wrench to turn the adjusting nuts at the
front bottom corners of the cooker.
To set the front, turn the feet bases to raise or lower.
32
Advertisement
Table of Contents
