Ipv6/Port Filter - D-Link DSL-124 User Manual
Wireless n300 adsl2+ modem router
Hide thumbs
Also See for DSL-124:
- Quick installation manual (8 pages) ,
- User manual (2 pages) ,
- Modem configuration manual (2 pages)
Table of Contents
Advertisement
Section 4 - Configuration
The IPv6/Port filter is used to restrict or allow certain types of IPv6 data packets through
the gateway. These filters are helpful in securing or restricting traffic on your local
network.
DEFAULT ACTION STATUS
Outgoing Default
Select whether to Permit or Deny data packets to flow out of the
WAN interface. The default setting is Permit.
Action:
Incoming Default
Select whether to Permit or Deny data packets to flow into the WAN
interface. The default setting is Permit.
Action:
To create a rule, fill out the following parameters.
Rule Action:
Select whether this rule will Permit or Deny data packets.
Protocol:
Select the protocol type: IPv6, ICMP6, TCP, or UDP.
Icmp6Type:
If ICMP6 is selected, select Ping6.
Direction:
Select the direction, either Upstream or Downstream.
Source IP Address
Enter the source IPv6 address and prefix length for the rule.
& Prefix Length:
Destination IP
Enter the destination IP address and subnet mask for the rule.
Address & Prefix
Length:
SPort:
Enter the source port number if TCP or UDP is selected.
Enter the destination port number if TCP or UDP is selected.
DPort:
D-Link DSL-124 Wireless N300 ADSL2+ Modem Router User Manual
RULE CONFIGURATION
IPv6/Port Filter
80
Advertisement
Table of Contents
