Table of Contents
Advertisement
Operating modes
This appliance can be used in exhaust-air mode or circulating-
air mode.
Exhaust air mode
The air which is drawn in is cleaned by the
grease filters and conveyed to the exterior
by a pipe system.
Note: The exhaust air must not be conveyed into a functioning
smoke or exhaust gas flue or into a shaft which is used to
ventilate installation rooms which contain heat-producing
appliances.
Before conveying the exhaust air into a non-functioning
■
smoke or exhaust gas flue, obtain the consent of the heating
engineer responsible.
If the exhaust air is conveyed through the outer wall, a
■
telescopic wall box should be used.
Operating the appliance
These instructions apply to several appliance variants. It is
possible that individual features are described which do not
apply to your appliance.
Note: Switch on the extractor hood when you start cooking and
switch it off again several minutes after you have finished
cooking. This is the most effective way of removing the kitchen
fumes.
Control panel
Explanation
Fan off
%
1
Fan speed 1
2
Fan speed 2
Fan run-on time
r
3
Fan speed 3
Intensive setting
°
Light On/Off
B
Setting the fan
Note: Always adjust the fan strength to meet current conditions.
If there is a large build-up of steam or fumes, select a high fan
setting.
Switching on
Press button 1, 2 or 3.
The
button and the set fan speed light up to confirm
%
activation.
Switching off
%
Press the
button.
6
Circulating-air mode
The air which is drawn in is cleaned by the
grease filters and an activated carbon filter and
conveyed back into the kitchen.
Note: To bind odours in circulating-air mode, you must install
an activated carbon filter. The different options for operating the
appliance in circulating-air mode can be found in the brochure.
Alternatively, ask your dealer. The required accessories are
available from specialist outlets, from customer service or from
the Online Shop. The accessory numbers can be found at the
end of the instructions for use.
Fan run-on time
Fan run-on is possible at any fan speed.
First, press the button corresponding to the desired fan
1.
speed: 1, 2 or 3 .
To activate fan run-on, press and hold button 2
2.
2 seconds.
The
button and the set fan speed flash to confirm
%
activation.
Press the
button to end the fan run-on early.
%
3.
Notes
The run-on time is 30 minutes for all fan speeds. Once this
■
time has elapsed, the ventilation and lights switch off
automatically.
The fan speed can be altered during the run-on time.
■
Intensive setting
You can use the intensive setting if there is a large build-up of
odours and fumes/vapours.
To activate the intensive setting, press and hold button 3
1.
2 seconds.
The
%
button lights up and button 3
activation.
To end the intensive setting early, press the
2.
Note: The intensive setting runs for 6 minutes. Once this time
has elapsed, the appliance returns to the fan speed previously
set.
Lighting
The lighting can be switched on and off independently of the
ventilation.
Press the
button.
@
Setting the brightness
When switching on the lights, press and hold the
2 seconds. The brightness is reduced.
Note: When switching on the lights again, the brightness is set
to maximum once again.
r
for
for
°
°
flashes to confirm
%
button.
@
button for
Advertisement
Table of Contents
