Bosch Professional GGS 30 LS Original Instructions Manual page 7

Hide thumbs Also See for Professional GGS 30 LS:

Original instructions manual (231 pages)

Table Of Contents

Available languages

(11) Spindle lock

a) Commercially available (not included in the scope of deliv-

ery)

Technical Data

Straight grinder

Article number

Rated power input

Power output

Rated speed

Speed adjustment range

Max. collet diameter

Spanner flat on the

– Clamping nut

– Grinding spindle

Spindle collar diameter

Grinding tool diameter, max.

Max. inner shank dimension L

Max. shank length

Constant electronic control

Speed preselection

KickBack Control

Restart protection

Soft start

Weight according to EPTA-Pro-

cedure 01:2014

Protection class

The specifications apply to a rated voltage [U] of 230 V. These spe-

cifications may vary at different voltages and in country-specific mod-

els.

Values can vary depending upon the product and are subject to ap-

plication and environmental conditions. For further information

www.bosch-professional.com/wac.

Fitting

Pull the plug out of the socket before carrying out any

work on the power tool.

Fitting Abrasive Tools Using an Open-Ended

Spanner and Spindle Lock (see figure A)

Only use open-ended spanners that are suitable and

undamaged (see "Technical Data").

– Clean the grinding spindle (3) and all the parts to be fit-

ted.

– Press the spindle lock (11) and turn the clamping nut (2)

by hand until locked.

– Press and hold the spindle lock and loosen the clamping

nut (2) with the open-ended spanner (9) by turning it an-

ticlockwise.

– Insert the straight shank of the grinding tool all the way

into the collet (1).

Bosch Power Tools

– Press the spindle lock (11) and tighten the application

The grinding tools must run completely concentrically. Do

not continue to use damaged grinding tools that are out of

balance. If the grinding tools are out of balance, they should

GGS 30 LS

be replaced.

3 601 BB5 0..

750

400

–1

min

33000

–1

min

7000−33000

Fitting Abrasive Tools Using Two Open-Ended

Spanners (see figure B)

●

– Clean the grinding spindle (3) and all the parts to be fit-

●

– Use an open-ended spanner (8) on the spanner flat of the

1.7

/ II

– Insert the straight shank of the grinding tool all the way

– Hold the grinding spindle (3) with the open-ended span-

The grinding tools must run completely concentrically. Do

not continue to use damaged grinding tools that are out of

balance. If the grinding tools are out of balance, they should

be replaced.

tool by placing the open-ended spanner (9) on the span-

ner flat and turning it clockwise.

Do not, under any circumstances, tighten the collet

with the clamping nut until a grinding tool has been

fitted. The collet may otherwise become damaged.

Only use mounted points with an appropriate shank

diameter. A mounting point with a shank diameter which

does not correspond to the tool holder of the power tool

(see "Technical data") cannot be held properly and will

damage the collet chuck.

The application tool must be clamped at least 10 mm.

The inner shank dimension L

can be used to calculate the

maximum permitted speed of the application tool from

the specifications provided by the manufacturer of the

application tool. It must not be less than the maximum

speed of the power tool.

Only use open-ended spanners that are suitable and

undamaged (see "Technical Data").

ted.

grinder spindle (3) to hold it in place.

Loosen the clamping nut (2) by placing an open-ended

spanner (9) on the spanner flat and turning it counter-

clockwise.