GE PBV10 Owner's Manual & Installation Instructions page 10

REVERSING THE DOOR SWING (Cont.)
Reinstalling Bottom Hinge
remove hinge pin from the bottom hinge, then
install it into the other screw hole on the bottom
hinge all the way in tightly. The plastic shim
should remain on the hinge pin during this
process.
hinge onto the refrigerator with the 2 bottom hinge
screws tightly.
3. Insert the two tabs on the lower side of the Toe
Phillips Head screwdriver.
Reinstalling Freezer Door and
Middle Hinge
screwdriver to install the bracket onto the right
side of the mullion with the 3 door lock bracket
Installation Instructions
Hex Head Screws
Reinstalling Freezer Door and
Middle Hinge (Cont.)
of the door, use a Phillips Head screwdriver to
door stopper, then remove the stopper and keep
stopper that came with the product onto the left
side with the same screw.
of the door, use a Phillips Head screwdriver to
remove the 1 screw securing door cap. Start from
the rear-left corner where the screw is removed,
push door cap forward while pulling it up to
disengage the left side clip, then do the same to
the right side to remove the door cap.
the door lock.
49-1000702 Rev. 1