Siemens SINUMERIK ONE NCU 1740 Equipment Manual page 112

Connectable components
12.1 NX10.3/NX15.3
Figure 12-6
Measuring sockets
Purpose
The T0, T1 and T2 measuring sockets output analog signals. Any signal interconnectable via
SINAMICS can be output on any measuring socket of the NX.
Note
The measuring sockets should be used exclusively for servicing purposes.
The measurements may be performed only by appropriately trained skilled personnel.
The measuring sockets are suitable only for multiple-spring wire plugs with a diameter of 2 mm.
112
Block diagram for digital inputs/outputs
Equipment Manual, 09/2022, A5E51087503B AC
NCU 1740