Connecting The Sawdust Extraction Appliance; Operation; Switching On And Off; Setting The Cutting Angle - Parkside PHKS 1350 C2 Translation Of The Original Instructions

Connecting the sawdust extraction
appliance
♦ Attach the adapter for dust extraction
chip ejector .
♦ Connect an approved dust and chip extraction
device.

Operation

Switching on and off
Switching on:
♦ Push the safety lock-out
and keep it pressed.
♦ Press the ON/OFF switch
running you can release the safety lock-out
Switching off:
♦ Release the ON/OFF switch

Setting the cutting angle

You can select the cutting angle with the help of the
cutting angle scale .
■ Release the wing screw on the cutting angle
preselector , set the desired angle on the
cutting angle scale
wing screw.
PHKS 1350 C2
to the
to the left or right
. Once the saw is
.
and then re-tighten the

Setting the cutting depth

NOTE
► We generally recommend setting the cutting
depth to approx. 3 mm more than the thickness
of the material. This ensures that you achieve
a clean cut.
♦ Release the locking screw
cutting depth on the cutting depth scale
then re-tighten the locking screw

Working with the circular saw

1. Switch on the device – as described in "Switching
on and off" – and then place it with the front
.
edge of the base plate
2. Align the machine using the guide fence
by using a marked line.
3. Hold the machine in both hands using the
handles and saw by exerting an even pressure.
Switching the laser on and off
Switching on:
♦ Press the ON/OFF switch laser
Switching off:
♦ Press the ON/OFF switch laser
NOTE
► If the batteries are spent, replace them with
two new 1.5 V alkaline button cells (type
AG 13/LR 44, e.g. GPA 76) .

Set rotational speed

■ Turn the adjusting wheel
rotational speed (arrow marking ▲)
(1 = lowest rotational speed/6 = highest rota-
tional speed):
Use the following suggested settings or set the rota-
tional speed on the adjusting wheel
, set the desired
and
.
on the material.
or
.
.
to the desired
as required.
GB │ IE │
23 ■