Figure 25: Air Screen/Flame Arrestor; Figure 26: Engine Oil Filter, Oil Pressure Transducer, And Oil Pressure Switch - Westerbeke 15.0 MEG-60Hz Operator's Manual

Operator Manual for Gasoline Generators
1. Clean using a good dish washing solution, rinse, and air dry.
2. Inspect the seal edges. If worn, install a new flame arrestor.
WARNING: The generator should never be started/operated without the air screen/flame arrestor properly installed.
5.4.6 How to Check the Engine Oil Pressure
The engine oil pressure is continuously monitored by the ECU and the generator control panel when the
engine is running. Should the oil pressure fall below a safe operating level, the generator shuts down and the
control panel low oil pressure fault LED illuminates. If this occurs, follow these steps:
1. Do not attempt to restart the generator.
2. Check the oil level and the condition of the oil.
3. If there is a loss of oil:
Inspect the engine for leaks.
a.
Inspect the wire connections at the oil pressure transducer and oil pressure switch.
b.
5.4.7 Battery Charging Circuit
The charging system consists of an alternator with a voltage regulator, an engine DC wiring harness, a
mounted DC circuit breaker and a battery with connecting cables. Because of the use of integrated circuits

Figure 25: Air Screen/Flame Arrestor

Figure 26: Engine Oil Filter, Oil Pressure Transducer, and Oil Pressure Switch

5 Maintenance
31
page