Table of Contents
Advertisement
Video Stamp: Display the current time of the event or GPS information of the video being
recorded.
Available options: Disable / Enable
Microphone: Turn on/off the microphone during video recording.
Available options: Disable / Enable
Volume: Set the speaker volume level.
Available options 0 ~7 (You can choose 0 to switch on Silent Mode)
Light Frequency: Select the appropriate frequency to avoid flashing A/C light.
Available options: 50Hz / 60Hz
Time-Lapse Video: Set a preferred time interval to make time-lapse videos. Time-lapse
video mode can only be enabled manually; once enabled, it will replace Normal recording mode.
Available options: Disable / 1 sec per shot / 2 sec per shot / 4 sec per shot
Note: To prevent the car battery from being completely drained, the DrivePro
automatically power off after 48 consecutive hours of recording in Time-Lapse Video mode.
G-Sensor: Adjust the sensitivity of the G-Sensor.
Available options: Disable / Low / Medium / High
Speed Unit: Set the measurement unit of speed.
Available options: Kilometer / Mile
Lane Departure Warning System (LDWS): Alert the driver if the driving speed exceeds
the value set ahead.
Available options: Disable / 60 kmh ~150 kmh (40 mph~95 mph)
Forward Collision Warning System (FCWS): Alert the driver if the driving speed
exceeds the value set ahead.
Available options: Disable / 60 kmh ~150 kmh (40 mph~95 mph)
Speed Alarm: Alert the driver with warning beeps if the driving speed exceeds the value
set ahead.
Available options: Disable / 60 kmh (40 mph) / ... / 150 kmh (95 mph)
Parking Mode: Determine if continuous recording is necessary according to motion
detection after the car engine is switched off (this mode will drain DrivePro 's battery).
17
will
Advertisement
Table of Contents
