SATO MB410i Operator's Manual page 8

Unit 1: Technical Data
PRINTING LANGUAGE
INTERFACES
RS-232C
USB
Optical Coupling
Bluetooth
Wireless LAN
RADIO FREQUENCY CHARACTERISTICS
2.4 FH1
Frequency Band Used
Modulation System
Assumed Distance of Interference
Availability of Frequency Change
Note 1
Note 2
SENSING
Gap (Transmissive)
I-Mark (Reflective)
Dispenser sensor
LABEL PRINTING MODES
Page 1-4
SATO Barcode Printer Language (SBPL)
Mini DIN (specified)
3-Wire Cooked Mode
Infrared communication (compliant with IrDA Standard
Bluetooth Specification
Wireless LAN interface (IEEE 802.11b/g)
TCP/IP (FTP, LPR, SOCKET)
Frequency Hopped - Spread Spectrum System
10 mm Maximum
All area is used, and exclusion of the band for equipment
for mobile object identification is impossible
Before using a wireless interface with this equipment,
make sure that any radio transmission/reception equip-
ment onsite does not share the same frequency range as
this product's wireless setup.
If any harmful radio interference should occur due to
operation of RF equipment that shares the same trans-
mission/reception characteristics, contact your nearest
dealer or service center to take appropriate measure to
prevent further interference (installing partitions).
Continuous Printing
Dispenser Printing
PN 9001190C
Mini B Type
Ver 1.2)
2.4GHz
Fixed
Fixed
Fixed
MB400i/MB410i Operator Manual