Vertical Lens Shift
Horizontal Lens Shift
Figure 3-19. Vertical and Horizontal Lens Shift Adjustments
By default, the VX-6000d is configured for a "floor/front" installation, in which the projector
is installed upright and in front of the screen. If it is installed behind the screen and/or
mounted on a ceiling, you must change the picture orientation. To do this:
1. Select an input OTHER THAN HDMI 1 or HDMI 2 on the DHD Controller.
2. Press MENU (on menu page 4) and enter the Service Menu passcode.
3. Select Service from the Main Menu.
4. Select Display Device from the Service Menu, then select Configure.
5. Press
, then choose Floor/Rear, Ceiling/Front or Ceiling/Rear, to match the
installation method.
You must enter a passcode to access the Service menu.
Note
Runco VX-6000d Installation/Operation Manual
43
Installation
3.9
Adjusting the Picture
Orientation