Step Four: Install Remote
1.
Connect the cable end to the cable anchor on the discharge
deflector before clipping the cable to the cable bracket on the
discharge chute.
2.
Route deflector remote cable along the left side of the chute
pedestal.
3.
Insert the barrel on the cable end into the bracket on left side of
chute deflector.
4.
Hold seal out of the way while routing the cable through the bracket
on the left side of the discharge chute, and then push the cable
fitting into the bracket.
5.
Push the seal securely over the end on the cable fitting to prevent
water from entering the cable.
6.
Check deflector travel. Adjust nut on cable end under handlebar to
obtain full travel, if necessary (see Remote Deflector Control in
Owners Manual.
Deflector Control Cable