Related Manuals for Pyle PATVR10
Summary of Contents for Pyle PATVR10
- Page 1 MOBILE AUDIO SYSTEM PATVR10 USER MANUAL • PLL Synthesizer Stereo Radio • USB Interface • Automatic Memory Storing • AUX IN function • Bluetooth A2DP Function...
-
Page 2: Table Of Contents
CONTENTS Installation ........... 3 Wiring Connection ......5 Operation ..........6 Location of keys ........6 Turn on/off the unit ........ 7 Sound adjustment ......... 7 Beep on/off ........... 7 EQ............7 Loudness ..........7 Loc on/off ..........7 Stereo/Mono ......... 7 Turn on/off the unit ........ -
Page 3: Installation
INSTALLATION Notes: Choose the mounting location where the unit will not interfere with the normal driving function of the driver. Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. - Page 4 INSTALLATION...
-
Page 5: Wiring Connection
WIRING CONNECTION ISO CONNECTION... -
Page 6: Operation
OPERATION LOCATION OF KEYS 1. BAND button 6. LCD 2. MODE button Power/SEL button 3. VOL + 8. CLOCK button 4. VOL - Seek down button Play/pause/SAVE button Seek up button... -
Page 7: Turn On/Off The Unit
OPERATION TURN ON/OFF THE UNIT local function. In LOC ON mode the unit will Press button (7) to turn on the unit. reduce the receiving sensitivity when you When the unit is on. Press and hold it for 2 search station. That means you can receive seconds to turn off the unit. -
Page 8: Auxiliary Input
OPERATION AUXILIARY INPUT →FM1→ FM2→ FM3→ AM (MW) 1→ AM (MW) 2 The unit can be connected a portable audio player through the AUX IN interface. And SELECTING STATION press MODE button to switch AUX IN Press button (10) or button (9) mode when inserted an audio source to the shortly to activate automatic seek... -
Page 9: Selecting Tracks In Single Step
OPERATION through this interface. When you connect cause files loss. company an USB driver through the interface, the assumes no responsibility for this. unit will search the MP3 /WMA files in the USB driver and start to play automatically. If BLUETOOTH OPERATION in other mode, you can also press MODE ... -
Page 10: Specification
SPECIFICATION GENERAL Power Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 100 (W) x 100 (D) x 70 (H) Tone Controls : ±10 dB Bass (at 100 Hz) : ±10 dB Treble (at 10 kHz) Maximum Output Power : 4 x 40 watts Current Drain : 10 Ampere (max.) -
Page 11: Trouble Shooting
TROUBLE SHOOTING Before going through the checklist, check wiring connection. If any of the problems persist after checklist has been made, consult your nearest service dealer. Symptom Cause Solution The car ignition switch is power supply No power. not on. connected to the car accessory circuits, but the engine is not moving, switch the ignition key...