Using the wireless radio frequency (RF)
headphones allows some passengers to
listen to the Auto Videosystem while
others can listen to the radio.
To select the wireless headphones, be
sure the on/off switch is in the 'on'
position and the volume is turned all the
way down. On/off and volume controls
are located on the right ear piece of the
headphones. The wireless headphones
will work from any position inside the
vehicle. The headphones are equipped
with a fine tuning adjustment on the
bottom of the left ear piece. Turn up the
volume until you hear static or system
sound. To tune out static or receive a
stronger stereo signal use this
adjustment. Once you have a good
signal, turn the volume up to desired
level.
WARNING:
To avoid potential damage to
your hearing, always turn the headphone
volume all the way down before placing them
over your ears. Once they are on, adjust the
volume to a comfortable level.
Figure 1.
FINE TUNING:
Your RF headphones operate within
a narrow radio frequency band and need
to be adjusted when you first put them on.
To do this there is a adjustment on the
bottom of the left ear piece, turn the
adjustment until the sound is clear and
static free.
See figure 2-H
HEADPHONE BATTERIES:
The battery compartment
is located on the right ear piece.
Replace with to "AAA" batteries
when needed. See Figure 2-B
Figure 2.