Table of Contents
Advertisement
Extra Rinse
4 u
8 u
6
Indicator pilot lights
7.1
Hoofdwas
7.2
Extra spoelen
Einde
7.3
At the end of the programme
The appliance stops automatically. The pilot light of the
button 6 and the pilot light corresponding to the just fin-
ished washing phase go off. The light 7.3 illuminates.
This appliance is designed for saving water. However, for people with very
delicate skin (allergic to detergents) it may be necessary to rinse the laundry
using an extra quantity of water.
Press simultaneously the buttons 4 and 5 for some seconds: the pilot light
7.2 comes on. This function stays permanently on. To remove it press the
same buttons again until the pilot light 7.2 goes off.
Start the programme by pressing the button 6
• To start the selected programme, press the button 6 , the corresponding
green pilot light stops flashing. The pilot light 7.1 illuminates to indicate
that the appliance starts operating and the door is locked. If you have
chosen a delayed start, the appliance will begin the countdown.
• To interrupt a programme which is running, press the button 6 : the
corresponding green pilot light starts flashing. It is possible to
change some options of a running programme before the programme
carries them out.
• To restart the programme from the point at which it was interrupted,
press the button 6 .
• After the programme has started the door is locked. If, for any reason,
you need to open the door , set firstly the appliance to PAUSE by pressing
the button 6 . After a few minutes it will be possible to open the door.
If the door remains locked, this means that the appliance is already
heating or that the water level is too high. In any case, do not try to force
the door!
If you cannot open the door but you need to open it you have to switch
the appliance off by turning the selector dial to
the door can be opened ( pay attention to the water level and tempera-
ture! ). After closing the door, it is necessary to select the programme
and options again and to press the button 6 .
• When you start the programme by pressing the button 6 , the washing
phase pilot light ( 7.1 ) illuminates. This means that the appliance is
operating.
• The additional rinses pilot light ( 7.2 ) illuminates when the appliance
perform an extra rinse.
• When the programme has finished the end cycle pilot light ( 7.3 ) comes
on.
If a programme or an option that ends with water left in
the tub has been selected and the door remains locked to
indicate that the water must be emptied out before opening
the door.
Follow the below instructions to empty out the water:
. After a few minutes
15
Advertisement
Table of Contents
