Table of Contents
Advertisement
RUGGEDCOM RX1511
Installation Guide
Figure 14: Removing a Module
1. Module 2. Chassis 3. Screw
5.
Install a new module or a blank module (to prevent the ingress of dust and dirt).
6.
[Optional] If necessary, install the device in the rack.
7.
Connect power to the device.
Installing a Module
To install a line module, do the following:
1.
Make sure power to the device has been disconnected and wait approximately two minutes for any remaining
energy to dissipate.
2.
[Optional] If the device is installed in a rack, remove it from the rack.
3.
Remove the current module from the slot.
4.
Insert the new module into the slot.
Installing/Removing Line Modules
Modules
1
2
3
Chapter 3
27
Advertisement
Table of Contents
