Table of Contents
Advertisement
Chapter 2
Installing the Device
8
Figure 12: RJ-45 Management Port
Communication Ports
Connect any of the available Ethernet ports on the device to a management switch and access the RUGGEDCOM
ROX II console and Web interfaces via the device's IP address. The factory default IP address for the RUGGEDCOM
RX1511 is https://192.168.0.2.
For more information about available ports, refer to
Section 2.8
Configuring the Device
Once the device is installed and connected to the network, it must be configured. All configuration management
is done via the RUGGEDCOM ROX II interface. For more information about configuring the device, refer to the
RUGGEDCOM ROX II User Guide associated with the installed software release.
16
Pin
1
Modules.
Chapter 3,
Name
1
RX+
2
RX-
3
TX+
4
Reserved (Do Not Connect)
5
Reserved (Do Not Connect)
6
TX-
7
Reserved (Do Not Connect)
8
Reserved (Do Not Connect)
RUGGEDCOM RX1511
Installation Guide
Description
Receive Data+
Receive Data-
Transmit Data+
Transmit Data-
Configuring the Device
Advertisement
Table of Contents
