Roper RUD8000R Dimensions

®
Undercounter Dishwasher
PRODUCT MODEL NUMBERS
RUD8000R RUD8050R
RUD8000S RUD8050S
Electrical: 120-volt, 60-Hz, AC-only, 15- or
20-amp. electrical supply. Use copper wire only. A
time-delay fuse or circuit breaker and separate
circuit is recommended.
Water: A hot water line with 20-120 psi
(138-862 kPa) water pressure. Water temperature
must be 120°F (49°C) at dishwasher. Use 3/8" O.D.
copper tubing with compression fitting or flexible
stainless steel braided fill line (1/2" minimum plastic
tubing is optional but not recommended). Use a 90°
elbow with 3/8" N.P.T. external pipe threads on one
end to connect to water inlet valve. Do not solder
within 6" (15.2 cm) from water inlet valve.
Drain: Use the new drain hose supplied with your
dishwasher. If this is not suitable, use a new drain
hose with a maximum length of 12 feet (3.7 m)
that meets all current AHAM/IAPMO test
standards, is resistant to heat and detergent, and
fits the drain connector of the dishwasher. Must
have a high drain loop 20" (50.8 cm) above the
subfloor or floor. Connect drain hose to waste tee or
disposer inlet above drain trap in house plumbing
and 20" (50.8 cm) minimum above the floor. An air
gap must be used if the drain hose is connected to
house plumbing lower than 20" (50.8 cm) above
subfloor or floor. Use 1/2" minimum I.D. drain line
fittings.
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
OVERALL DIMENSIONS
3/4" (1.9 cm) 25-1/4" (64.1 cm)
insulation – may be
compressed (not used
on all models)
21" (53.3 cm)
CABINET OPENING DIMENSIONS
2-1/2"
(6.4 cm)‡
1-3/4"
(4.4 cm)‡
4"
(10.2 cm)‡
3"
(7.6 cm)‡
1-3/4"
(4.4 cm)‡ (10.8 cm)‡
Cut holes in shaded area of cabinet walls or floor as specified below:
water line – 1/2" (1.3 cm)
drain line – 1-1/2" (3.8 cm)
direct wire – 3/4" (1.9 cm)
power supply cord – 1-1/2" (3.8 cm)
* Measured from the lowest point on the underside of countertop. May be
reduced to 33-7/8" (86 cm) by removing wheels from dishwasher.
** Minimum, measured from narrowest point of opening.
*** May be increased to 6-7/8" (17.5 cm) if height of opening is 34-1/2" (87.6 cm)
at its lowest point.
‡ Both sides
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
24-1/2"
(62.2 cm)
33-7/8"
(86 cm) min. with
wheels removed
Side view
24" (61 cm)**
All surfaces must be free
from intrusions
6-3/4"
(17.2 cm)‡
10-1/2"
3"
(26.7 cm)
(7.6 cm)‡
6-1/4"
(15.9 cm)***
2"
9"
(5.1 cm)
(22.9 cm)
4-1/4"
23-7/8"
(60.6 cm)
Rear view
34"
(86.4 cm)
min.*
24"
(61 cm)
min.
2"
(5.1 cm)‡
6-1/4"
(15.9 cm)‡***
10"
(25.4 cm)
clear area‡
Ref. 8575348
02-13-07