Table of Contents
Advertisement
Preferred DNS server
Network Advanced Settings
802.1X mode
802.1X Identity
MD5 Password
802.1X CA Certificate
802.1X Client
Certificate
HTTP Proxy
HTTPS Proxy
Bypass Proxy For
Layer 3 QoS for SIP
Layer 3 QoS for RTP
Enable DHCP VLAN
Enable Manual VLAN
Configuration
Layer 2 QoS
802.1Q/VLAN Tag
Layer 2 QoS 802.1p
Priority Value
PC Port Mode
PC Port VLAN Tag
Enter the Preferred DNS Server for IPv6.
Allows the user to enable/disable 802.1X mode on the phone. The default
value is disabled. To enable 802.1X mode, this field should be set to EAP-
MD5, users may also choose EAP-TLS, or EAP-PEAPv0/MSCHAPv2.
Enter the Identity information for the 802.1x mode.
Note: Letters, digits and special characters including @ and – are accepted.
Enter the MD5 Password for the 802.1X mode.
Note: Letters, digits and special characters including @ and – are accepted.
Uploads / deletes the 802.1X CA certificate to the phone; or delete existed
802.1X CA certificate from the phone.
Uploads / deletes 802.1X Client certificate to the phone; or delete existed
802.1X Client certificate from the phone.
Specifies the HTTP proxy URL for the phone to send packets to. The proxy
server will act as an intermediary to route the packets to the destination.
Specifies the HTTPS proxy URL for the phone to send packets to. The proxy
server will act as an intermediary to route the packets to the destination.
Enter host names that do not require a proxy to reach. Those names should
be separated by commas.
Defines the Layer 3 QoS parameter for SIP. This value is used for IP
Precedence, Diff-Serv or MPLS. The default value is 26.
Defines the Layer 3 QoS parameter for RTP. This value is used for IP
Precedence, Diff-Serv or MPLS. The default value is 46.
Enables auto configure for VLAN settings through DHCP. Disabled by default.
Enables/disables manual VLAN configuration. When this option is set to
Disabled, the phone will bypass VLAN configuration and only use the DHCP
VLAN to configure VLAN tag and priority. Default is "Enabled".
Assigns the VLAN Tag of the Layer 2 QoS packets. The valid range is 0 –
4094.The default value is 0.
Assigns the priority value of the Layer2 QoS packets. The valid range is 0 –
7. The default value is 0.
Configure the PC port mode. When set to "Mirrored", the traffic in the LAN
port will go through PC port as well and packets can be captured by
connecting a PC to the PC port. The default setting is "Enabled".
Assigns the VLAN Tag of the PC port. The valid range is 0 – 4094.The default
value is 0.
GRP261x/GRP2624/GRP2634 Administration Guide
Version 1.0.5.48
P a g e
|
92
Advertisement
Table of Contents
