Roland Sound Canvas Digital SC-D70 Owner's Manual page 42

Appendix
Viewing the flow chart
...
...
fig.flow.e
No Sound
Is the power turned on for your SC-D70?
Is the MIDI indicator lit?
Check the following.
• Are the SC-D70 and the computer properly connected, and are
you starting up the SC-D70 in the mode appropriate for the way
the SC-D70 is connected? Refer once more to "Connecting to
a Computer" in the Startup Manual and check the connections.
• Is your software's MIDI Thru function set to ON?
• If in MIDI mode, is the volume level on the expression pedal for
the connected MIDI device turned completely down?
You hear sound!
It is also possible that the parameter settings of
the SK-500 have become incorrect.
To remedy such situation, transmit the GS reset.
You hear sound!
Check the following points on the software
that you are using.
• Has the volume been lowered?
• Has the volume been muted (silenced)?
You hear sound!
42
Proceed according to the directions inside.
Answer the questions inside.
You hear sound!
NO
Is the MIDI output destination set correctly?
• Read the sections in the Startup Manual on the driver installation and
settings, then make the settings.
• If the correct MIDI driver for the MIDI data output destination is not
selected, no sounds will be played by the SC-D70.
* For details on the MIDI output settings, refer to the owner's manual of
the software you are using.
YES
When installing the software,
did you install the driver?
You hear sound!
NO
YES