Roland S-4000S Installation Manual page 2

Installing the S-BP to the S-4000S
1
Remove the two screws from each module
(SI-AD4 or SO-DA4) installed in the
S-4000S.
2
Extract the module from the S-4000S.
3
Install an S-BP in the opening left by the
removed module.
4
Secure the module in place using the two
screws removed when detaching the
module.
S-BP
* 0 4 2 3 2 8 5
The module shown
in the figure is the
SO-DA4. The
removal procedures
for the SI-AD4 and
SO-DA4 are the
same.
Extraction of the
SI-AD4 or SO-DA4
may be
accomplished more
easily by inserting
an XLR plug into a
connector on the
module, then
pulling out the
module while
gripping the plug.
6 - 0 1
04232856 '06-1-1N
*