Adjusting The Footrest; Removing And Installing The Engine Hood; Side Discharge - Toro TimeCutter 18-44Z Operator's Manual

Z with side discharge mower
Hide thumbs Also See for TimeCutter 18-44Z:
Table of Contents

Advertisement

2
Figure 14
1. Lever position for pushing
the machine
To Operate the Machine
Move each bypass levers to the inside and pull them
rearward, completely through the slot (Fig. 14).
Note: The machine will not drive unless the bypass levers
are pulled out.

Adjusting the Footrest

The footrest can be adjusted forward or backward for
maximum operator comfort.
1. Lift up the footrest and place the rods in the same hole
positions (Fig. 15).
3
Figure 15
1. Footrest
2. Rod
1
m–7276
2. Lever position for
operating the machine
1
2
3
m–6423
3. Hole positions
17
Removing and Installing the
Engine Hood
1. To remove the hood, loosen the knobs and then pull the
hood back and up (Fig. 16).
3
Figure 16
1. Engine hood
2. To install the hood, put the hooks into the slots and slide
forward (Fig. 17).
3. Install the knobs into the engine hood (Fig. 16).
1
2
Figure 17
1. Engine hood

Side Discharge

The mower has a hinged grass deflector that disperses
clippings to the side and down toward the turf.
2
m–6424
2. Knob
m–6425
2. Hook

Advertisement

Table of Contents
loading

This manual is also suitable for:

74351

Table of Contents