Attaching The Divided Pickup With Screws - Roland GK-2A Owner's Manual

Attaching the Divided Pickup with Screws

You can also use screws to secure the Divided Pickup. Marking the position of the Pickup and
checking the height is exactly the same as in "a. Attaching the Divided Pickup with double–sided
tape". Refer to that section before proceeding.
* When attaching the Divided Pickup with screws, you need a 13 mm space between the body of the guitar and
the strings.
1. Place the Divided Pickup in the
appropriate position. Carefully mark the
location of the screw holes (at either end of
the Pickup) on the guitar.
2. Remove the strings from the guitar.
3. Very carefully drill holes at the marked
locations.
* The holes should be about 2 mm (0.08") in
diameter and approximately 2 to 3 mm deep.
* If the guitar is made of a hard wood (maple, rock
maple, cherry, rosewood, etc.), make the holes
slightly larger than 2 mm.
4. Place the supplied springs on the screws
between the bottom of the Pickup and the
guitar. Then tighten the screws:
fig.14
5. Put the strings back on the guitar and tune
them properly.
6. Adjust the height of the Pickup.
Adjust the height of the Pickup by loosening
or tightening the screws. Use the clearance
gauge to set the proper Pickup height.
* Afterwards, you will need to adjust the Pickup
sensitivity on the [GR]. If the signal level from
the Divided Pickup is too high, lower the Pickup
slightly.
INSTALLATION
17