Changing The Battery - Roland FZ-5 Fuzz Owner's Manual

Changing the Battery

When the indicator goes dim or no longer
lights while the effect is on, it means that the
battery is nearly dead and must be replaced.
Replace the battery following the steps below.
* The use of an AC adaptor is recommended as the
unit's power consumption is relatively high. Should
you prefer to use a battery, please use the alkaline type.
fig.replace-battery.eps_90
Thumbscrew
Battery Snap
Cord
Battery
Snap
9V Battery
Pedal
Spring Base
Coil Spring
Guide Bush
Hole
Battery Housing
1. Loosen the thumbscrew at the front of
the pedal, and then lift the pedal
upwards to open the unit.
* The thumbscrew can be left in the pedal while
changing the battery.
2. Remove the old battery from the battery
housing, and remove the snap cord con-
nected to it.
3. Connect the snap cord to the new battery,
and place the battery inside the battery
housing.
* Be sure to carefully observe the battery's polarity (+
versus -).
4. Slip the coil spring onto the spring base
on the back of the pedal, and then close
the pedal.
* Carefully avoid getting the snap cord caught in the
pedal, coil spring, and battery housing.
5. Finally, insert the thumbscrew into the
guide bush hole and fasten it securely.
13