Panel Operation - Boss Giga Delay DD-20 Owner's Manual

Panel Operation

In order to follow along with the instructions given here, you should start out by
having effects switched ON (press the ON/OFF pedal and confirm that the ON/
OFF indicator has lighted), and press the SELECT button to switch MANUAL
(MANUAL indicator has lighted in green).
Also set the knobs as shown in the illustration.
fig.17
1. Rotate the MODE knob to select an appropriate delay effect from the eleven
available types.
2. Adjust the delay time by rotating the DELAY TIME knob.
* Pressing the knob down as you turn it cause the delay time to change more rapidly.
Furthermore, the rate at which it changes also varies according to how the knob is turned.
More detail, refer to "Operating the DELAY TIME Knob" (p. 17).
3. Rotate the F. BACK knob to adjust the amount of the feedback.
4. Adjust the tone of the effect sound with the TONE knobs.
The frequency response is flat when the knob is at the center position.
You can usually leave the knob at the center position.
5. Adjust the volume of the effect sound with the E.LEVEL knob.
Saving the Current Delay Time as the "Manual" Setting
If you press the DELAY TIME knob after adjusting the delay time, the current
delay time is then stored to the DD-20 as the "Manual" setting.
This setting is preserved even while the power is turned off, and is selected as
the default delay time setting (display) when the power is turned on again.
Operation
9