Changing The Scenes Assigned To Markers; Clearing Auto Scene; Preventing Auto Scene From Functioning - Boss BR-1180CD Function Manual

Calling up scenes automatically during playback and recording (Auto Scene)
Changing the scenes
assigned to markers
1. Press [UTILITY], then press [CURSOR] to move the
cursor to "MARKER," then press [ENTER].
2. Use [CURSOR] to move the cursor to "No." and then
select the marker number whose assignment you want
to change with the TIME/VALUE dial.
fig.03
3. Use [CURSOR] to move the cursor to "SCENE" and
then select the number for the scene you want to assign
with the TIME/VALUE dial.
fig.04
You can also select from Scene Number 1–50. If you do
not want to assign any scene to the marker, select "OFF."
* An asterisk ("*") appears in front of the scene number when
parameters are stored in that scene. Note that if you select a
scene with no asterisk (an open scene), the Auto Scene is
automatically prevented from being carried out.
* If "- - -" appears as the scene number, it means that no
corresponding marker has been created yet. In this case, you
will be unable to select the scene number.
4. To have these settings be remembered, you need to
perform a "Song Store."
"Saving a song (Song Store)"; p. 80 in the Owner's Manual
4

Clearing Auto Scene

1. Press MARK [<<][>>] to move to the location where the
marker you want to clear is set.
The marker field of the display will indicate the marker
you want to clear.
2. Press [CLEAR] in the MARKER section.
The marker is cleared. Any scene assigned to that marker
is also cleared simultaneously.
* If a scene is also assigned to another marker, only the marker is
cleared, and not the scene.
Preventing Auto Scene from
functioning
Moving the track faders manually while Auto Scene is active
can hinder your work by causing changes in track volume
levels when you don't want them.
You can prevent such problems by using the procedure
below to disable the Auto Scene functions.
1. Press [UTILITY], then press [CURSOR] to move the
cursor to "SYSTEM," then press [ENTER].
This brings up the System screen.
2. Use [CURSOR] to move the cursor to "Auto Scene" and
switch the function to "OFF" with the TIME/VALUE
dial.
The Auto Scene function is now disabled.
fig.05
* To enable Auto Scene, set "Auto Scene" to "ON" again.
3. Carry out Song Store to store these settings in memory.
"Saving a song (Song Store)"; p. 80 in the Owner's Manual
* Take care not to forget if "Auto Scene" is set to "OFF" when
saving a song, or Auto Scene will not function afterwards. We
recommend returning this setting to "ON" as often as possible
when saving songs.