Table of Contents
Advertisement
f For the LAN cable between a twisted-pair-cable transmitter and the projector, use a cable that meets the following criteria:
g Compatible with CAT5e or higher
g Shielded type (including connectors)
g Straight-through
g Single wire
f The maximum transmission distance between the twisted-pair-cable transmitter and the projector is 100 m (328'1"). If this distance is
exceeded, image and sound may be disrupted and may cause a malfunction in LAN communication.
f When laying cables between a twisted-pair-cable transmitter and the projector, check that cable characteristics are compatible with CAT5e
or higher using tools such as a cable tester or cable analyzer.
When using a relay connector midway, include it in the measurement.
f Do not use a hub between a twisted-pair-cable transmitter and the projector.
f Do not pull cables forcefully. Also, do not bend or fold cables unnecessarily.
f To reduce the effects of noise as much as possible, stretch out the cables between the twisted-pair-cable transmitter and the projector
without any loops.
f Lay the cables between a twisted-pair-cable transmitter and the projector away from other cables, particularly power cables.
f When installing multiple cables, run them side by side along the shortest distance possible without bundling them together.
f After laying the cables, confirm that the value of [SIGNAL QUALITY] in the [NETWORK] menu → [DIGITAL LINK STATUS] is displayed in
green (indicates normal quality). (x page 106)
f For twisted-pair-cable transmitters of other manufacturers of which the operation has been verified with the projector, visit the website
(https://panasonic.net/cns/projector/). Note that the verification for devices of other manufacturers has been made for the items set by
Panasonic Connect Co., Ltd., and not all the operations have been verified. For operation or performance problems caused by the devices
of other manufacturers, contact the respective manufacturers.
Accessing from the web browser
1)
Start up the web browser on the computer.
2)
Enter the IP address set on the projector into the URL entry field of the web browser.
3)
Enter the user name and the password.
f The factory default setting of the user name is user1 (user rights)/admin1 (administrator rights) and the password is panasonic (lower
case).
4)
Click OK.
f The [Projector status] page is displayed.
Note
f If you use a web browser to control the projector, set [WEB CONTROL] to [ON] in [NETWORK CONTROL] (x page 107).
Chapter 4 Settings — [NETWORK] menu
ENGLISH - 109
Advertisement
Table of Contents
