Before You Start Playing; Connect The Pedal Cable; Connect The Speaker Cable (Hp-7); Connect The Power Cord - Roland HP-3 Owner's Manual

Before You Start Playing

Connect the Pedal Cable

Insert the pedal cable into the Pedal connector on the
rear panel of the HP-7/3.
fig.00-01
HP-3
Connect the Speaker Cable
(HP-7)
As shown in the diagram, connect the speaker cable
leading from the speaker box of the stand to the
speaker connector located on the rear panel of the HP-7.
Push the speaker cable in until it clicks into position.
Clip portion
NOTE
Do not place containers holding liquids (such as flower vases),
insecticide, perfume, alcohol, or similar substances on top of
this piano.
The speakers of this piano are mounted beneath the upper
surface, and face upwards. Malfunctions or accidents may occur
if liquids contact any part of the speakers.
Speakers
10
HP-7
HP-7 Rear
Speaker connector
Speaker cable

Connect the Power Cord

Insert the included power cable into the AC inlet on the
bottom panel of the HP-7/3, and then plug it into an
electrical outlet.
NOTE
Be sure to use the supplied power cord.
fig.00-02
Setting Up the Music Stand
(HP-3)
Insert the music stand into the two holes as shown in
the following diagram.
fig.00-03
NOTE
Before moving the piano, be sure to remove the music stand to
prevent accidents.
Setting Up the Music Stand
(HP-7)
1.
Grasping the music stand with both hands, lift it
toward you until its in the upright position.
2.
Use the support on the back of the music stand to
keep the stand in place.
The angle of the music stand can be set to any of three
positions.
fig.mu_stand
2
1