Connection Examples; Federal Communications Commission Radio Frequency Interference Statement - Roland Acoustic Chorus AC-100 Owner's Manual

Connection Examples

* To prevent malfunction and/or damage to speakers or other devices, always turn down the volume,
and turn off the power on all devices before making any connections.
Rhythm macnine
Acoustic guitar
(with pickup)
RADIO FREQUENCY INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Unauthorized changes or modification to this system can void the users authority to operate this equipment.
This equipment requires shielded interface cables in order to meet FCC class B Limit.
CLASS B
This digital apparatus does not exceed the Class B limits for radio noise emissions set out in the Radio Interference
Regulations of the Canadian Department of Communications.
CLASSE B
Cet appareil numérique ne dépasse pas les limites de la classe B au niveau des émissions de bruits radioélectriques
fixés dans le Règlement des signaux parasites par le ministère canadien des Communications.
Howling could be produced depending on
the location of microphones relative to
speakers. This can be remedied by:
1. Changing the orientation of the
microphone(s).
2. Relocating microphone(s) at a greater
distance from speakers.
3. Lowering volume levels.
INPUT
PUSH SOURCE
AUX
MIC I
AUX MIC
INPUT SHAPE
HIGH LOW
I PIEZO I ACTIVE
GUITAR
Front Panel
LINE IN
Mixer
This product complies with the requirements of European Directive 89/336/EEC.
FEDERAL COMMUNICATIONS COMMISSION
PUSH
2
The pin assignment for the XLR connectors is as
shown above. Before making any connections,
make sure that this pin assignment is compatible
with that of all your other devices.
HPF
HPF
B A
OUTPUT INPUT
Effector
NOTICE
AVIS
1 2
1
1 : GND
2 : COLD
3 : HOT
3
3
Rear Panel
LINE OUT GUITAR EFFECT FOOT SWITCH
B A RETURN SEND REVERB CHORUS
Foot switches
For Europe
For the USA
For Canada
7