Media Input; Monitor Volume; Master Volume - Peavey PV i 8500 Operating Manual

Media Input

XLr BaLaNCED INPut
10
Channel 8 is designed specifically for pre-recorded (pro-
gram) music, but can also be used with a microphone.
This XLR input provides a balanced low impedance con-
nection.
MIC Or MEDIa SELECt ButtON
11
This control selects between the low impedance XLR (9)
and the RCA / 1/8", or iPod
MEDIa INPut
12a
These inputs, both RCA and 1/8" accept a stereo input
12b
from the output of an MP3 player, CD player, tape deck or
other similar device.
FLS ®
13
When feedback occurs, the corresponding LED of the
frequency that is closest to the frequency that is feeding
back will illuminate over the slider to be adjusted. Slowly
bring the corresponding slider down until feedback is
gone. The LED will remain illuminated for a few seconds
after the feedback is gone.
GraPHIC EQ
14
These 9-band EQs are designed for 12dB cut or boost.
These EQs are used to make minor adjustments to the
overall mix and should be used sparingly.
aMP LEVEL LED LaDDEr
15
These LEDs indicated the signal level going to the power
amplifier. The top LED indicates LIMIT and activation
of our revolutionary DDT
Peavey's award winning speaker protection circuit is
built into the PV
matically to maximize the power amplifier without fear of
distortion.
POWEr aMP INPut SELECt
16
This control allows the user to select whether the 2nd
power amplifier receives its signal from the Master Vol-
ume (18) or from the Monitor Volume (17) control. This
allows the user to run both power amps for mains, or use
power amp 1 for mains and power amp 2 for monitors.

MONItOr VOLuME

17
The master level control adjusts the level of the signal
coming out the Monitor send 1/4" jack. It can also be
assigned to feed the 2nd power amplifier via selector
switch (16).

MaStEr VOLuME

18
The master level control for the main mix and the overall
volume of the powered mixer.
MaIN EQ aSSIGN
19
This switch allows the user the ability to assign the
graphic EQ (14) to either the Main or Monitor mix.
All manuals and user guides at all-guides.com
® input (PV ® i 8500 only).
™
speaker protection circuit.
®
8500/PVi 8500 and activated auto-
17
10
12a
15
16
17
11
12b
13
14
15
18
19