NuTone QTR090C Quick Start Manual page 2

INSTALLATION WITH "RAISED" MOTOR BRACKET
1. TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS: Switch power off at service panel
and lock the service disconnecting means to prevent power
from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten
a prominent warning device, such as a tag, to the service
panel.
LIGHT
WIRE
2. Remove fan GRILLE by squeezing two GRILLE SPRINGS
and sliding them out of their mounting slots on each side of
the fan housing. Disconnect LIGHT WIRE from fan (if fan is
equipped with a light). Set grille assembly aside for now.
3. Disconnect FAN MOTOR PLUG.
4. Partially install (2) #8-32 x 5/8 screws (included) into threaded
holes in speaker bracket - only so ends of screws are flush
with bottom surface of speaker bracket. Note: Installing
screws below flush will make the next couple of steps difficult.
GRILLE SPRING
GRILLE
FAN MOTOR
PLUG
#8-32 X 5/8"
SCREWS
#8-32 X 5/8"
SCREWS
FAN MOTOR PLUG
5. Insert speaker into fan housing. Make sure SPEAKER
BRACKET hooks over edge of BRACKET OPENING.
6. Make sure rear surface of speaker is located as close to
wall of fan housing as possible.
7. Turn #8-32 X 5/8" SCREWS (partially installed in Step
3) until they make contact with FAN PARTITION PLATE.
Alternately tighten both screws. DO NOT OVERTIGHTEN.
8. Insert SPEAKER PLUG into power receptacle where
motor plug was disconnected.
9. Connect FAN MOTOR PLUG into SPEAKER WIRE
RECEPTACLE.
10. Plug in LIGHT WIRE (if applicable) and re-install grille that
were unplugged and removed in Step 2.
11. Turn on power to fan.
12. Go to Bluetooth Speaker Operation section for Bluetooth
®
speaker operating instructions.
MODEL SPKACC
Page 2
FAN PARTITION
PLATE
BRACKET
OPENING
SPEAKER PLUG
SPEAKER WIRE
RECEPTACLE
®