Resetting The Grease Filter Operating Hours Counter - Miele DA 7090 W Operating And Installation Instructions

Cleaning and care
Cleaning the grease filters by hand
^ Clean the filters with a soft nylon
brush in a mild solution of hot water
and a little washing-up liquid.
Do not use "neat" washing-up liquid.
Do not use:
– cleaning agents containing
descaling agents,
– powder cleaners, cream cleaners or
abrasive all-purpose cleaners.
– oven sprays.
Cleaning the grease filters in the
dishwasher
^ Place the filters with the short side
upright in the lower basket, ensuring
the spray arm is not obstructed.
^ Do not wash at more than 65° C. If a
Miele dishwasher is being used,
select the Sensor wash programme.
^ Use a mild dishwasher detergent.
Depending on the cleaning agent
used, cleaning the filters in a
dishwasher can cause permanent
discolouration to the surface.
However, this will not affect the
functioning of the filters in any way.
18
^ After cleaning, leave the filters to dry
on an absorbent surface before
replacing them.
^ When removing the filters for
cleaning, also clean the now
accessible areas of the housing to
prevent the risk of these catching fire.
to prevent the risk of these catching
fire.
^ Replace the grease filters.
Resetting the Grease filter operating
hours counter
After cleaning, the operating hours
counter needs to be reset.
^ Whilst the fan is switched on, touch
the Grease filter sensor l for
approx. 3 seconds until only the 1
sensor is flashing.
The Grease filter sensor l will go
out.
If you want to clean the grease filters
before the operating hours counter has
reached its maximum:
^ Touch the Grease filter sensor l for
approx. 6 seconds until only the
1 sensor is flashing.