Table of Contents
Advertisement
a Canopy
b Holders for the charcoal filters
c Grease filters
d Controls
The symbols act as sensors. Touch the
sensors to select the function you
require.
An audible tone sounds briefly to
confirm selection.
e Hob lighting
f Charcoal filters (2)
g Air outlet grilles
h Sensor for the hob lighting
This sensor can be used to switch the
hob lighting on and off and is also a
dimmer switch.
i Sensor for switching the fan on
and off
j Sensors for selecting the fan
power level
k Sensor for the run-on option
This sensor activates the run-on option.
The fan can be set to switch off
automatically after either 5 or 15
minutes.
Guide to the appliance
l Sensor for the grease filters
The sensor lights up when the grease
filters need to be cleaned.
It is used to reset the operating hours
counter every time the grease filters are
cleaned (see "Cleaning and care").
It can also be used to check and alter
the operating hours counter.
m Sensor for the charcoal filters
The sensor lights up when the charcoal
filters need to be cleaned. For this to
happen, the operating hours counter
needs to be activated before the
appliance is used for the first time.
The sensor is used to reset the
operating hours counter every time the
charcoal filters are replaced (see
"Cleaning and care").
It can also be used to check and alter
the operating hours counter.
For information about using the
appliance, see "Operation".
9
Advertisement
Table of Contents
