Craftsman 137.322860 Operator's Manual page 23

Mounting instructions:
1. For stationary use, place the saw
in the desired location, directly on a
workbench where there is room for
handling and proper support of the
workpiece. The base of the saw has
four mounting holes. Bolt the base
of the miter saw (1) to the work
surface (5), using the fastening
method as shown in Fig K.
Fig. K
2
3
4
1
5
6
7 8
9
NOTE: Mounting hardware is not
included with this tool. Bolts, nuts,
washers and screws must be
purchased separately.
2. For portable use, place the
miter saw on a 3/4 in. thick piece
of plywood. Bolt the base of the
miter saw securely to the plywood
using the mounting holes on the
base. Use C-clamps to clamp this
mounting board to a stable work
surface at the worksite. (Fig. L)
1. Miter saw base
2. Hex head bolt
3. Rubber washer
4. Flat washer
5. Workbench
6. Flat washer
7. Lockwasher
8. Hex nut
9. Jam nut
Fig. L
3/4 in.
plywood
NOTE: If a miter saw stand is used,
please follow all instructions shown in
that product's instructions for proper
mounting.
23