Model Number Notes - Trane Voyager TS 150-300 Series Installation, Operation And Maintenance Manual

Model Number Description
7 = Clogged Filter Switch, Fan
Failure
Switch and Discharge Air
9
Sensing
A = Condensate Drain Pan Overflow
Switch
B = Clogged Filter Switch and
Condensate Drain Pan Overflow
9
Switch
C = Fan Failure Switch and
Condensate Drain Pan Overflow
9
Switch
D = Discharge Air Sensing and
Condensate Drain Pan Overflow
9
Switch
E = Clogged Filter Switch, Fan
Failure
Switch and Condensate Drain
Pan
9
Overflow Switch
F = Clogged Filter Switch, Discharge
Air Sensing Tube and
Condensate
Drain Pan Overflow Switch
G = Fan Failure Switch, Discharge Air
Sensing Tube and Condensate
Drain Pan Overflow Switch
H = Clogged Filter Switch, Fan
Failure
Switch, Discharge Air Sensing
and Condensate Drain Pan
9
Overflow Switch
Digit 26 - System Monitoring
Controls
0 = No Monitoring Controls
A = Demand Control Ventilation
17
(CO )
2
B = FDD (Fault Detection and
Diagnostics)
C = FDD (Fault Detection
Diagnostics)
and Demand Control Ventilation
17
(CO )
2
Digit 27 - Unit Hardware
Enhancements
0 = No Enhancements
1 = Stainless Steel Drain Pan
Digit 28 - Short Circuit Current
Rating
0 = Standard SCCR
20,
A = 65kA SCCR Option
Digit 31 - Advanced Unit
Controls
0 = Standard Unit Controls
23
1 = Human Interface
Note: Most Factory Installed Options
available for Downflow Air
Discharge units only. Please
verify with ordering system for
availability.

Model Number Notes

1. Some field set up required.
2. Requires ReliaTel Options
Module.
6
3. Requires Economizer.
nd
4. All 22
reheat coil (B) require additional
factory installed options: Frostat,
and 2" pleated filters.
5. Must be ordered with Through-
the-Base Electrical option or
Horizontal-Side Access and either
Unit Mounted Disconnect or
Circuit Breaker.
6. Available factory installed on
downflow AND horizontal units.
Verify with ordering system.
7. Cannot be fused.
8. Must be factory installed when
using Through-the-Base Options.
9. ReliaTel Options Module is
9
required when ordering the
following accessories: Clogged
9
Filter Switch, Fan Fail Switch,
Condensate Overflow Switch,
Discharge Air Sensing Kit,
Frostat, Ventilation Override,
Smoke Detector,
Dehumidification and
Modulating Gas Heat Furnace.
10. Option cannot be ordered in
conjunction with field installed
economizer on downflow units.
Must be factory installed. The
return air smoke detector may
not fit up or work properly on the
Voyager units when used in
conjunction with 3
accessories (such as bolt on heat
wheels, economizers, and power
exhaust). Do not order the return
air smoke detectors when using
this type of accessory.
11. Unit mounted disconnect and
circuit breakers are mutually
21
exclusive of each other.
12. Through-the-base electrical
option or Horizontal-Side Access
must be ordered with either unit
mounted disconnect or circuit
breaker.
13. Available on high efficiency units
only.
14. All Factory Installed Options are
Built-to-Order. Check order
services for estimated production
cycle.
15. TCI is for use with non-VariTrac
systems and VariTrac systems.
digit model numbers for
rd
party
16. For use with multi-speed and
SZVAV units only.
17. Demand Control Ventilation
Option includes wiring only. The
C0 sensor is a field-installed only
2
option.
18. Frostat is standard on VAV, and
high efficiency units.
19. Supply and/or return smoke
detector may not be used with the
plenum smoke detector.
20. Only available where MOP is
above 60A.
21. 575 VAC option is 25kA.
22. Standard filters are not available
with Low Leak Economizers.
23. Human Interface is standard with
FDD (Fault Detection
Diagnostics).
24. Must be used with BACnet™
open protocol.
25. Apply to 50Hz units only.
RT-SVX25Q-EN